Korg Electric Keyboard ユーザーズマニュアル

Specifies the direction in which “AMS1 (Time Mod. AMS1)” 
will affect the release time. With positive (+) values of “I 
(AMS1 Intensity),” setting this parameter to + will allow 
AMS1 to lengthen the time, and setting this parameter to – 
will allow AMS1 to shorten the time. With a setting of 0 
there will be no change.

These parameters are the settings for “AMS2” to control the 
“Time” parameters of the filter 1 EG (☞“AMS1 (Time Moc. 
AMS1)”–“R (AMS1 SW Release)”).

■

☞ “Write Program” (1.1–1c), “Copy Oscillator,” “Swap 

Oscillator” (2.1–1d)

If you select “Sync Both EGs” from the Utility menu and 
press the [F8] key, a check mark will appear at the left of 
“Sync Both EGs.” In this state, the filter 1 EG and the filter 2 
EG can be edited simultaneously. (Editing either one will 
cause the other to change.)

“Sync Both EGs” cannot sync the filter EG and amp EG 
independently. For example if you sync in 5.1–3d, it will 
be synced here as well.

This can be selected only if “Mode (Oscillator Mode)” 
(2.1–1a) is Double.

Indicates settings for filter 2, which controls the tone of oscil-
lator 2. You can select either a 24 dB/oct low pass filter with 
resonance, or a 12 dB/oct low pass filter and 12 dB/oct high 
pass filter connected in series. Filter 2 can be used when 
“Mode (Oscillator Mode)” (2.1–1a) is Double. (☞“PROG 4.1: 
Ed-Filter 1”)

Indicates settings for amp 1 which controls the volume of 
oscillator 1. Pan settings are also made here.

These parameters control the volume and pan of oscillator 1.

Sets the volume of oscillator 1.

The volume of a program can be controlled by CC#7 
(volume) and CC#11 (expression). The resulting level is 
determined by summing the values of CC#7 and 
CC#11. The Global MIDI channel “MIDI Channel” 
(GLOBAL 2.1–1a) is used for control.

Sets the pan (stereo location) of oscillator 1.
A setting of L001 places the sound at far left, C064 in the 
center, and R127 to far right.

The sound will be heard from a different location 

at each note-on.

This can be controlled by CC#10 (panpot). A CC#10 
value of 0 or 1 will place the sound at the far left, a 
value of 64 will place the sound at the location specified 
by the “Pan” setting for each oscillator, and a value of 
127

 will place the sound at the far right. This is con-

trolled on the global MIDI channel “MIDI Channel” 
(GLOBAL 2.1–1a).

Filter 1 EG changes (Time) (AMS = Velocity, Intensity = a positive (+) value)

Note-on

Note-off

Note-on

Note-off

Note-on

Note-off

Softly played note with “A,” 
“D,” “S” and “R” set to + 
(setting of 4.1–5a: Filter 1 EG)

Strongly played note with 
“A,”  “D,” “S” and “R” set to +

Strongly played note with 
“A,”  “D,” “S” and “R” set to –

5.1–1a

5.1–1b

5.1–1d

5.1–1c