Black Box AC2000A ユーザーズマニュアル

 

 

7

2. Installation 

The video cables are DVI male to male.  The audio cables are 3.5mm mini-
stereo.  When connecting to a PC’s serial port for remote control of the DVI 
extender, an RS-232 to PC cable is required (Customer provided).  A 
detachable 3-terminal mating connector is provided with the unit.  The 
function of each pin is silkscreened above the 3-terminal input connector on 
the rear of the unit.  Below is a diagram for connecting this port to a PC’s 
DB9 serial port. 

 

The AC2000A-S has a DVI video input, a mini-stereo audio input, a RS232 
terminal block, Local DVI output, Local audio output, and two UTP ports 
for video, audio and RS232 extension. Power plug is a standard IEC 
connector, (IEC 60320 C14) 

The AC2000A-R has two UTP input ports, a DVI output, audio output, and 
RS232 output. 

Plug in the desired video and audio sources to the INPUT DVI and INPUT 
AUD connectors on the back of the AC2000A-S.  
Connect local video and audio devices; such as a monitor to the OUTPUT 
DVI and AUD connectors if desired.  For remote video and audio; two 
CAT5 cables are used to connect AC2000A-S (sender) to an AC2000A-R 
(receiver) through UTP Extension port LINK A and LINK B connectors. 

NOTE 

Do not cross the A & B Link cables when connecting to the receiver unit. 

Failure to observe this precaution could result in damage to the unit 

Connect the RS-232 to PC cable if remote serial control is desired. 
Connect the included power cord to the AC2000A-S and apply power. 
Select the desired EDID routing path using the front panel buttons, through 
RS-232 serial commands, or GUI software.