Behringer B315A ユーザーズマニュアル

EUROLIVE B312A/B315A User Manual 

The 

[3]

LINK OUTPUT is directly connected to the inputs 

of the B312A/B315A and carries the input signal with no 
processing applied. In this way, you can route the signal 
to the input of another device (for example, a second 
B312A/B315A)
To set the volume of the LINE or MIC signal, use the 

[4]

LEVEL control. The left half of the control range is for 
attenuating  the LINE signal. The right half is for raising 
the level of the MIC signal.
The 

[5]

CLIP LED lights up when signal distortion occurs. 

Reduce the volume with the LEVEL control until the CLIP 
LED does not light up any more, or occasionally lights up at 
signal peaks.

The 

[6]

HIGH control adjusts the high-frequency range.

Use the 

[7]

LOW control to raise the level of the low-frequency 

range.
The 

[8]

PWR LED lights up when the loudspeaker is put into 

operation.

You can replace fuses at the 

[9]

FUSE SWITCH of the 

B312A/B315A. Always replace fuses with the same type. 
Please follow the instructions given in the chapter  
“Specifications.”
The mains connection is established using a cable with 

[10]

an IEC mains connector. This cable is delivered with the 
B312A/B315A. To avoid ground-loop hum, loudspeakers 
and mixing consoles should be connected to the same power 
circuit.
Press 

[11]

POWER to turn on your B312A/B315A.

[12]

Fig.2.2: Control elements and connections B312A and B315A)