American Dj XDM-352 ユーザーズマニュアル
Inputs:
Microphone
Microphone
1.5mV, 600 Ohm
Phono
1.2mV, 47kOhm
Line
80mV, 27kOhm
Output
20V, peak to peak
Frequency range
20Hz-20KHz, ± 1dB
Distortion
<0.03%
S/N-ratio
>80dB
Talkover
-15dB
Tone control
Treble: 10Khz ± 12dB
Bass: 100 Hz ± 12dB
Bass: 100 Hz ± 12dB
7-Band Graphic Equalizer
± 12dB at 60Hz, 150Hz
400Hz, 1KHz, 2.4KHz,
8KHz, and 16KHz
400Hz, 1KHz, 2.4KHz,
8KHz, and 16KHz
Headphone impedance
16 Ohms
Power supply
AC115/230V, 50/60Hz
Dimensions
19” W x 9.5” D x 3.25” H
482 x 242 x 108 mm
482 x 242 x 108 mm
Weight
12 lbs. / 4.5 kg
© American DJ® AUDIO Los Angeles, CA 90058 USA
Specifications subject to change without notice. XDM-352 User Instructions page 5
Replacing the Crossfader
Technical Specifications - model XDM-352
Instructions for replacing the crossfader:
• Disconnect from main power supply.
• Remove the fader knob.
• Remove the two outer screws.
• Take the fader out and unplug the connection cable.
• Connect the new fader and replace back into mixer.
• Remove the fader knob.
• Remove the two outer screws.
• Take the fader out and unplug the connection cable.
• Connect the new fader and replace back into mixer.
Inputs and Outputs (Cont.)
(35) AC CONNECTION - AC power cord.
(36) FUSE - Fuseholder. Only replace the fuse when the device is disconnected from mains. Only replace by fuses of the
same power and rating.
(37) AC VOLTAGE SELECTOR - Make sure that the selector is properly set.
(36) FUSE - Fuseholder. Only replace the fuse when the device is disconnected from mains. Only replace by fuses of the
same power and rating.
(37) AC VOLTAGE SELECTOR - Make sure that the selector is properly set.