iOptron 8000D ユーザーズマニュアル

ページ / 9
iOptron Corp. | 6E Gill Street | Woburn, MA 01801 USA | (781) 935-2800 | Toll Free (866) 399-4587 | www.iOptron.com 
Quick Setup 
 
1.  A. Setup tripod: Expand the tripod legs and lock the 
Tripod Spreader so that the tripod legs stay open 
(Figure 1). Adjust the tripod height by unlocking and 
re-locking the tripod legs to desired height. Position 
the tripod so that the Alignment Peg faces north. (The 
Alignment Peg may be moved to the opposite 
position if used at latitude lower than 20º to avoid 
counterweights hitting the tripod leg)
 
      
                 
 
 
Figure 1 
 
1.  B. Setup pier: Unthread the Pier Locking Screw 
(This screw is only used for pier storage). 
Separate the Pier Base with Legs from the Pier Tube. 
Remove the Pull Rods from inside the pier. 
 
 
Figure 2 
 
 
 
Figure 3 
Move the Pier Foot from the end to the side. 
 
 
              
 
Figure 4 
Spread the Pier Leg. Put the Pier Tube onto the Pier 
Base, with Pier Alignment Slot aligned over the 
Alignment Tab on the Pier Base.  
 
 
 
Figure 5 
Adjust the length of the three Pull Rods.  Hook one 
end of a Pull Rod onto a bolt located on the Pier Leg 
and the other Pull Rod end onto the mounting beam 
inside the Pier Tube. Evenly tighten the Pull Rods. 
Make sure there is no gap between the Pier Base 
and Pier Tube.  
 
  
 
 
 
Alignment Peg 
Tripod Spreader 
Tripod Lock 
Pier Locking 
Screw 
Pier Base 
Pier Tube 
Pull Rods
Pier Foot
Pier Foot
(Storage 
Position)
Pier Leg
Pier Base
Align Slot
Align Tab