iOptron 8405 ユーザーズマニュアル

2. Telescope Assembly

Step 1. Preparing the Tripod

Unlock the tripod leg locks (#10).
Extend tripod legs.
Lock the leg locks afterwards.

Step 1a.

Pull tripod legs apart to a fully opened position.
Tighten the center tripod lock knob (#9) to a firm feel to secure
the tripod legs.

Caution: Make sure you loosen this lock knob before
collapsing the tripod to store away.

Step 2. Attaching the Mount

Position center of the mount base to the threaded bolt of height
extender (#13) on tripod.
Turn the mount until it is securely fastened to the tripod.
Use height adjustment handle (#8) to adjust the height of the
mount if needed. (Caution: Do not extend beyond 6 inches.)
Make sure to tighten the tripod height extender lock (#12).

Step 3. Installing Batteries (not included)

Pull the batteries compartment cover (shown) open.
Gently pull the batteries holder (shown next) out of the
compartment to avoid breaking the attached wires.

Step 3a.

Insert 8 AA batteries (not included) according to the diagrams on
the holder.**
Replace the holder back into the batteries compartment and
replace the cover.

Note: fit the batteries holder back into the compartment with the
attached wires at the bottom right corner (see arrow in the
photo)

** Use only fresh batteries; do not mix fresh and old
batteries;insufficient battery power may cause error
messages;optional AC Adapter and Car Charger
accessories are available at

www.ioptron.com

Threaded

bolt #13

Height lock

(#12)

#10

Height adjust.

(#8)