Siemens 9300 ユーザーズマニュアル
9300 Series User’s Guide
Internal Modem Connections
Chapter 5 - Features and Applications
Page 113
Internal Modem Connections
This option is only available on the 9330 and 9350 meters.
Refer to the “Hardware Reference” chapter for internal modem specifications.
Connection to the internal modem is made via the RJ-11 jack, or two captured wire
connectors, located on the right side of the meter. Connect the meter to the
telephone network with an FCC Part 68 compliant telephone cord (that has two
male RJ-11 plugs). If you have the captured wire connector option, connect the
meter to the telephone system with the (bare wire to RJ-11) cable provided. If you
have the CTR-21 compliant internal modem option, you may also require an
adaptor to interface with your regional telephone jack.
connectors, located on the right side of the meter. Connect the meter to the
telephone network with an FCC Part 68 compliant telephone cord (that has two
male RJ-11 plugs). If you have the captured wire connector option, connect the
meter to the telephone system with the (bare wire to RJ-11) cable provided. If you
have the CTR-21 compliant internal modem option, you may also require an
adaptor to interface with your regional telephone jack.
The meter with an internal modem uses the modem to communicate to a master
device (e.g. server computer with WinPM.Net software) over the telephone
network.
device (e.g. server computer with WinPM.Net software) over the telephone
network.
Meter Setup for Modem Communications
To enable communications through the meter’s internal modem, you must
configure the Comm 1 Communications module. The Baud Rate, Unit ID, and
Protocol setup registers must properly match your system, and the initialization
string for the internal modem must be set up using the ModemInit register.
configure the Comm 1 Communications module. The Baud Rate, Unit ID, and
Protocol setup registers must properly match your system, and the initialization
string for the internal modem must be set up using the ModemInit register.
ModemInit Setup Register
The ModemInit string register defines the initialization string for the internal
modem, with a maximum of 47 characters.
modem, with a maximum of 47 characters.
Edit the ModemInit register and enter the initialization string desired. The string is
sent to the modem as soon as you download the COM 1 module. Note that the
string is also sent to the modem whenever the meter is powered up, or whenever
the baud rate in the Comm 1 Communications module is changed.
sent to the modem as soon as you download the COM 1 module. Note that the
string is also sent to the modem whenever the meter is powered up, or whenever
the baud rate in the Comm 1 Communications module is changed.
Any changes to the Modem Init or Baud Rate setup registers while the modem is
online will cause the modem to disconnect from the phone line.
online will cause the modem to disconnect from the phone line.
Telephone
Network