Ariens 90203200 ユーザーズマニュアル

IMPORTANT: 

WHEN UNPACKING AND AS SEM BLING 

TILLER, BE CAREFUL NOT TO STRETCH OR KINK 

CABLE(S).

•  Cut cable ties securing handles.
• 

Slowly lift  handle as sem bly up, route cable(s) as shown  

and align han dle holes with handle panel hole and 

slot.

•  Loosely assemble hardware as shown.    the

shorter (1" long) hex bolt is assembled in lower hole of 

handle.  Repeat for opposite side.   Tight en all hard-

ware se cure ly. 

•  Cut cable ties securing tiller to skid and remove tiller 

from skid.

•  Remove screws securing depth stake to skid and dis-

card the screws.

dep

th_st

ak

e_4

• 

Handle height may be adjusted to better suit operator.  

(See “HANDLE HEIGHT” in the Service and Ad just-

 ments section of this manual.) 

•  Tilling width may be adjusted to better handle your 

tilling con di tions (See “TINE ARRANGEMENT” in the 

Service and Adjustments section of this manual.) 

•  Check tine operation before first use.  (See “TINE 

OPERATION CHECK” in the Service and Adjustments 

section of this manual.)  

•  Loosen nut “A”.
•  Insert stake support between engine brack et halves 

with stake spring down. 

•  Bolt stake support to engine brackets with bolts, lock 

washers and nuts. Tight en se curely. Tighten nut “A”.

•  Depth stake must move freely. If it does not, loosen 

support bolt.

&4

(ANDLEª0ANEL?