Oregon Scientific WMR180A ユーザーズマニュアル

5

To  completely  disconnect  from  power,  unplug  adaptor 
from the mains.

E

U

/U

K 

.  Slide open the battery door.
2.  Insert the batteries, matching the polarities (+ / -).
3.  Press RESEt after each battery change.
4.  Close the battery door.

  NotE    Do  not  use  rechargeable  batteries.  It  is 
recommended  that  you  use  alkaline  batteries  with  this 
product for longer performance.

  NotE    Batteries  should  not  be  exposed  to  excessive 
heat such as sunshine or fire.

Weather Forecast Area

Battery in the base station is 
low. 

 will show when AC 

adaptor is disconnected.

Temperature or 
Humidity Area

The displayed channel 
indicates the outdoor sensor 
for which battery is low.

Wind Speed / Wind 
Direction / Wind Chil 
Area

Battery in the wind sensor 
is low.

UVI / Barometer / 
Rainfall Area

Battery in the UV / Rain 
sensor is low.

Before  proceeding  to  install  sensors  outside,  please 
verify communication to the base station.
  NotE    Unit  will  search  only  for  already  registered 
sensors or new sensors reset within last 30 minutes. To 
register a new sensor, reset sensor prior to search.

Press SELECt until the selected area icon   is in the 
top right display area.

•  Wind speed:  Gently rotate the wind vane and confirm a 

numerical reading on the base station, e.g., 

.

•  Wind  direction  indicator.  Move  the  direction  of  the 

wind indication and verify the icon moves in the same 
direction 

.

.  Press SELECt until the selected area icon   is in the 

bottom left display area.

2.  Press UP / doWN to select channel  

 and verify 

a numerical reading.

.  Press SELECt until the selected area icon   is in the 

middle right display area.

2.  Press ModE until 

 is displayed.

3.  Tilt the tipping funnel on the rain gauge several times 

and verify a numerical reading on the base station.

 tIP  If no reading is displayed for a sensor, press and 
hold the SEARCH button on the base station to initiate a 
wireless sensor search.

To ensure you are running the latest and most compatible 
software  for  your  unit,  install  Virtual  Weather  Station 
software from the CD enclosed in this package. Follow 
the software setup instructions.
 NotE  The software must be installed before data can 
be uploaded.

.  Plug one end of the USB cable into the USB hub and 

the other end into the PC’s USB port.

 

2.  On the base station, press and hold UP and doWN 

together.  Then, press SEARCH on USB hub.

 on LCD screen

LED blinking rapidly

USB hub and base station are 
being synchronized.

LED blinking slowly

Lost link.  Connection could not 
be made

LED continuously on

Connection successful.

•  For  continuous  uploading  of  real  time  data,  keep  the 

USB  communications  hub  connected  to  the  computer 
using USB cable provided and ensure computer is on.

WMR180_UM_EN_R7.indd   5

2011/5/30   3:56:56 PM