Oregon Scientific BAR908HGA ユーザーズマニュアル

EN

10

2.  Insert the batteries.
3.  Set the channel and radio signal format (RTGN318D 

only). The switches are located in the battery 
compartment.

Channel

If you are using more 
than one sensor, select a 
different channel for each 
sensor.

Radio Signal 
Format

EU (DCF) / UK (MSF) 
(RTGN318D only)

4.   Press RESET.
5.   Close the battery compartment.
For best results:
•   Insert  the  batteries  and  select  the  unit,  channel,  and 

radio signal format before you mount the sensor.

•   Place the sensor out of direct sunlight and 

moisture.

•  Do  not  place  the  sensor  more  than  70  metres   

(230 feet) from the main (indoor) unit.

•  Position  the  sensor  so  that  it  faces  the  main   

(indoor) unit, minimizing obstructions such as  
doors, walls, and furniture.

•  Place  the  sensor  in  a  location  with  a  clear  view  to   

the sky, away from metallic or electronic objects.

•  Position  the  sensor  close  to  the  main  unit  during   

cold winter months as below-freezing 

 

temperatures may affect battery performance and  

signal transmission.

NOTE The transmission range may vary and is subject to 
the receiving range of the main unit.
You  may  need  to  experiment  with  various  locations  to  get 
the best results.

Data  is  sent  from  the  sensor(s)  every  60  Seconds.  The 
reception icon shown in the Temperature / Humidity Area 
indicates the status.

Main unit is searching 
for sensors.

At least 1 channel has 
been found.

Sensor 1 is sending 
data. (The number 
shows which sensor is 
selected.)

--- shows in 
Temperature / 
Humidity Area

The selected sensor 
cannot be found. Search 
for the sensor or check 
batteries.

To search for a Thermo / Hygro sensor, press SELECT to 
navigate to the Temperature / Humidity Area. 

 will show