Poulan 96082001700 ユーザーズマニュアル

Replace V-belts if they have stretched considerably or if 

they show cracks or frayed edges.  There are two (2) V-

belts - forward (inside) and reverse (outside).
Belt guard must be removed to service belts.  See “TO 

REMOVE BELT GUARD”  in this section of manual.
NOTE:  Observe carefully routing of both belts and lo ca tion 

of all belt guides before removing belts.
BELT REMOVAL

•  Remove reverse idler pulley from idler arm.
•  Remove reverse (outside) V-belt.
• 

Remove forward (inside) V-belt from transmission pul-

 ley first and then from engine pulley.

• 

Install new forward (inside) V-belt to engine pulley first 

then to transmission pulley.  Be sure belt is positioned 

on inside groove of both pulleys, inside all belt guides 

and rests on idler pulley.

• 

Before installing reverse (outside) V-belt, turn belt “in side 

out”.  Twist so wide, flat surface of belt is to inside.

• 

Wrap V-belt around reverse idler pulley and re as semble 

idler to idler arm.  Tighten securely.  Be sure belt is 

between reverse idler pulley and idler arm pin.

• 

Install belt to outside groove of transmission pulley.  Be 

sure belt is inside all belt guides and rests on outside 

groove of engine pulley.

•  See “TINE OPERATION CHECK” in this section of 

manual.

belts_10