Amtrol fpt-1 プリント

ページ / 2
READ CAREFULLY THE PRODUCT 
INSTALLATION & OPERATION INSTRUCTIONS.  
FAILURE TO FOLLOW THE INSTRUCTIONS AND WARNINGS IN 
THE MANUAL MAY RESULT IN SERIOUS OR FATAL INJURY AND/
OR PROPERTY DAMAGE, AND WILL VOID THE PRODUCT 
WARRANTY.  THIS PRODUCT MUST BE INSTALLED BY A 
QUALIFIED PROFESSIONAL.  FOLLOW ALL APPLICABLE LOCAL 
AND STATE CODES AND REGULATIONS, IN THE ABSENCE OF 
SUCH CODES, FOLLOW THE CURRENT EDITIONS OF THE 
NATIONAL PLUMBING CODE AND NATIONAL ELECTRIC CODE, 
AS APPLICABLE. 
Excessive pressure can cause tank to explode.  
Exercise care when filling a tank with air so the 
pressure does not exceed that required or does not exceed the working 
pressure of the tank as stamped on the nameplate.  Failure to follow 
these instructions will result in serious personal injury or death and 
property damage.
CALIFORNIA PROPOSITION 65 WARNING! This product contains a 
chemical known by the State of California to cause cancer and to cause 
birth defects or other reproductive harm. (California Installer/Contractor 
- California law requires that this notice be given to consumer/end user 
of this product.) 
For more information: www.amtrol.com/prop65.html
This Product, like most Products under pressure, 
may over time corrode, weaken and burst or 
explode, causing serious or fatal injury, leaking or flooding and/or 
property damage.  To minimize risk, a licensed professional must install 
and periodically inspect and service the Product.  A drip pan connected 
to an adequate drain must be installed if leaking or flooding could cause 
property damage.  Do not locate in an area where leakage of the tank or 
connections could cause property damage to the area adjacent to the 
appliance or to lower floors of the structure.
EXPLOSION OR RUPTURE HAZARD A relief 
valve must be installed to prevent pressure in 
excess of local code requirement or maximum working pressure 
designated in the Product Manual, whichever is less.  Do not expose 
Product to freezing temperatures or temperatures in excess of 200° F.  
Do not adjust the pre-charge or re-pressure this 
Product except for any adjustments required at 
the time of initial installation, especially if Product is corroded, damaged 
or with diminished integrity. Adjustments to pre-charge must be done at 
ambient temperature only.  Failure to properly size the Product or 
follow these instructions may result in excessive strain on the system 
and lead to Product failure, serious or fatal personal injury, leakage 
and/or property damage.
NOTE:  Inspect for shipping damage and notify freight carrier or store where purchased immediately if damage is present.  To avoid risk of personal 
injury and property damage, if the product appears to be malfunctioning or shows signs of corrosion, call a qualified professional immediately.  Current 
copies of the Product manual can be viewed at www.amtrol.com.  Use proper safety equipment when installing. 
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT YOU TO POTENTIAL PERSONAL INJURY AND OTHER 
HAZARDS. OBEY ALL SAFETY MESSAGES THAT FOLLOW THIS SYMBOL TO REDUCE THE RISK OF PERSONAL 
INJURY AS WELL AS PROPERTY DAMAGE.
FIRE-X-TROL
® 
WET PIPE SPRINKLER SYSTEM EXPANSION CHAMBER
INSTALLATION & OPERATION INSTRUCTIONS
Models FPT-1(C) through FPT-210V(C)