Ridgid DP15501 ユーザーズマニュアル

To lock switch in OFF position, hold
switch IN with one hand and remove key
with other hand.

For your own safety, 

always push the switch “OFF” when 
drill press is not in use, remove key 
and keep it in a safe place, also, in 
the event of a power failure (all of 
your lights go out) or blown fuse or 
tripped circuit breaker, turn switch 
off, lock it and remove the key. This 
will prevent the drill press from 
starting up again when the power 
comes back on.

To drill a blind hole (not all the way
through) to a given depth, proceed as fol-
lows.

1. Mark the depth of the hole on the work-

piece.

2. Loosen the depth scale lock.
3. With the switch OFF, bring the drill bit

down until the tip of lips of the bit are
even with the mark.

4. Turn the depth scale counterclockwise

until it stops moving.

5. Tighten the depth scale lock.
6. The drill bit will stop at this depth until the

depth scale is readjusted.

1. With the power off, loosen the depth

scale lock.

2. Place workpiece on table. Adjust table

until the tip of the drill bit is just a little
above the top of the workpiece, turn the
depth scale counterclockwise to zero.

3. Turn the depth scale clockwise until the

depth scale indicator points to the
desired drilling depth on the depth scale.

4. Tighten the depth scale lock.
5. The chuck or drill will now be stopped

after traveling downward the distance
selected on the depth scale.