Hitachi C 8FSHE ユーザーズマニュアル

-21-

      grain) are better than those on the sides marked ( B ).
(9) Crown molding cutting
      This machine can cut two types of crown molding workpieces by combining the miter and bevel cutting
      operations. Figure 25 shows two common crown molding types having angles of (θ) 38° and 45°. For
      the typical crown molding fittings, see Fig. 26.

The table below shows the miter angle and the bevel angle settings that are ideal for the two crown molding
types.
NOTE : For convenience, positive stops are provided for the miter setting (left and right 31.6°)

For miter cut setting
      If the turn table has been set to either of the angles described, move the turn table adjusting side handle
      a little to the right and left to stabilize the position and to properly align the miter scale and the tip of the
   indicator before the operation starts.
For bevel cut setting
      Move handle on miter section to the right and left and check that the position is stable and the angle
      scale and the tip of the indicator are properly aligned. Then tighten the clamp lever.

To process crown molding at positions
 1 

 

and 

 

4 

 

in Fig. 26.

To process crown molding at positions
 2 

 

and 

 

3

 

  in Fig. 26.

Type of
crown
molding

Miter angle
setting

Bevel angle
setting

Miter angle
setting

Bevel angle
setting

45° type

Right 35.3°
(  mark)

Left 30°
(  mark)

Left 35.3°
(  mark)

Left 30°
(  mark)

38° type

Right 31.6°
(  mark)

Left 33.9°
(  mark)

Left 31.6°
(  mark)

Left 33.9°
(  mark)

30° and 33.9° left slant setting method
  1 Loosen the clamp lever and slant to the left a little at a time
      while pushing the set pin into the main unit. At this time, the
      set pin will enter one step and fit into the 30° left slant and
      33.9° left slant setting slots.
  2 With the set pin in the slot as described above, setting to the
      30° left slant position is possible by pushing to the right side.
  3 Also, with the set pin in the slot as described above, setting
      to the 33.9° left slant position is possible by pushing to the
      left side.
  4 Look at the bevel scale and indicator to recheck whether or
      not the settings match and then tighten the clamp lever.

(1) Setting to cut crown moldings at positions

 

 1 

 

and

 

 4 

 

in Fig. 26 (see Fig. 28; tilt the head to the left):

  1 Turn the turn table to the right and set the miter angle as follows:
* For 45° type crown moldings: 35.3° (    mark)
* For 38° type crown moldings: 31.6° (    mark)

Fig. 27

Fig. 26

Fig. 25

Bevel scale

Tighten

Clamp
lever