Fusion L702B ユーザーズマニュアル
7
LITHIUM FUNCTIONS AND PARAMETERS
When a Lithium type battery is selected, the following functions and parameters are
available. The 2
available. The 2
nd
and 3
rd
pages (shown below) are accessed by moving the line
selection down arrow off the bottom of the page.
Page 3
Page 1
Page 2
11]LiPo 3S 2200mAh
CHG. : 2.1A 4.20V/C
DCHG. :10.0A 3.0V/C
STORE MODE START
CUT.TEMPER. : 55°C
MAX.CAPACITY: 120%
SAFETY TIMER: 120min
CHARGE RATE : 2C
TCS CAPACITY: 90%
TCS END ACT : CONTI.
Cut-off Temperature
Cut-off when x% of
capacity is reached.
Cut-off if maximum
time is reached
Max Charge Rate
TCS (Terminal
Capacity Selection)
What should happen
when the TCS
capacity is reached?
Charge
Store Mode
Discharge
‘CHG.’ – CHARGE
This line shows the charge current and the maximum cell voltage which can be edited
by press the ‘Enter’ button to highlight the parameter, then the ‘Inc’ and ‘Dec’
buttons to edit the value. The default charge current for a Lithium battery is set to
1C (1 x capacity), however this can be adjusted from 0.1 to 20 Amps.
by press the ‘Enter’ button to highlight the parameter, then the ‘Inc’ and ‘Dec’
buttons to edit the value. The default charge current for a Lithium battery is set to
1C (1 x capacity), however this can be adjusted from 0.1 to 20 Amps.
N.B. For safety the charge current is limited to the capacity x charge rate (see
Maximum Charge Rate setting). If you want to increase the charge current above 2C,
you must first increase the maximum charge rate before you can increase the charge
current.
Maximum Charge Rate setting). If you want to increase the charge current above 2C,
you must first increase the maximum charge rate before you can increase the charge
current.
Normally, the maximum cell voltage should be left at the default value (LiPo=4.2V,
LiIo=4.1V & LiFe=3.7V), but in very cold weather a Lithium Polymer pack can be
overcharged at 4.2V, so reducing the maximum charge voltage to 4.1V can increase
the life of your pack.
LiIo=4.1V & LiFe=3.7V), but in very cold weather a Lithium Polymer pack can be
overcharged at 4.2V, so reducing the maximum charge voltage to 4.1V can increase
the life of your pack.
Press the ‘Enter’ button for 2 seconds on this line to start the charge.
‘DCHG.’ - DISCHARGE
This shows the discharge current and the cut-off voltage per cell. Pressing the ‘Enter’
button for 2 seconds with this line selected will start the discharge.
button for 2 seconds with this line selected will start the discharge.
STORE MODE START
It is recommended that Lithium batteries are not left in a fully charged or discharged
state for long periods of time, especially when stored in a cold environment.
state for long periods of time, especially when stored in a cold environment.