Grizzly G0755 ユーザーズマニュアル
Model G0755 (Mfg. Since 1/13)
-21-
Headstock
Movement
the headstock travels up and down the column,
and tilts 90° left and right relative to the table.
and tilts 90° left and right relative to the table.
Raising/Lowering Headstock
Loosen the lock handles shown in
Figure 13, then
use the Elevation (z-Axis) switch (see
Figure 14)
on the control panel to raise/lower the headstock.
Depth Stop
the depth stop limits the downward movement of
the cutting tool. With the use of the depth pointer
adjustment knob (see
the cutting tool. With the use of the depth pointer
adjustment knob (see
D in Figure 12), it can be
adjusted anywhere within 0"–5". this is useful
when performing repeat operations.
when performing repeat operations.
the limit stops shown in
Figure 15 stop head-
stock travel when contacted by the limit block.
the headstock can also be raised/lowered by
hand using the crank shown in
hand using the crank shown in
Figure 16.
Note: Lock the headstock in place by re-tighten-
ing the lock handles before beginning operation to
avoid unexpected headstock movement.
ing the lock handles before beginning operation to
avoid unexpected headstock movement.
The z-axis crank will rotate rapidly and may
cause impact injuries if left attached during
powered z-axis operation. Always remove
z-axis crank before using the switch on the
control panel.
Figure 13. Lock handles for headstock elevation.
Lock
handles
Figure 15. z-axis limit controls.
Limit
stops
Limit
Block
Figure 14. Elevation switch that controls
motorized head travel.
Elevation
switch
Figure 16. z-axis crank.
Crank