Grizzly G1199 ユーザーズマニュアル
-8-
G1199/G1200 Drill Press
Figure 4.
Figure 3.
Worm pinion installed.
Figure 5.
3.
Insert the worm pinion inside the table brack-
et and attach the crank handle by tightening
the setscrew.
et and attach the crank handle by tightening
the setscrew.
Figure 3.
4.
The rack has a section on each end with no
teeth. The end with the larger blank section is
the top. Place the rack in the slot in the table
bracket with the top facing up. Position it so
the teeth mesh with the worm pinion. While
holding it in that position, slide the table brack-
et and rack down the column until the bottom
of the rack meets the base of the column.
teeth. The end with the larger blank section is
the top. Place the rack in the slot in the table
bracket with the top facing up. Position it so
the teeth mesh with the worm pinion. While
holding it in that position, slide the table brack-
et and rack down the column until the bottom
of the rack meets the base of the column.
Figure 4.
The bevel in the rack should fit into
the bevel in the top of the base.
5.
Slide the rack ring down the column until it fits
over the beveled section at the top of the rack.
Tighten the setscrew in the rack ring leaving
enough slack between the rack and the rack
ring to allow the rack to move freely around
the column.
over the beveled section at the top of the rack.
Tighten the setscrew in the rack ring leaving
enough slack between the rack and the rack
ring to allow the rack to move freely around
the column.
Figure 5. Do not over-tighten or
you may crack the rack ring casting.
6.
Place the head assembly onto the top of the
column and lower it until it sits on the shoulder
machined into the top of the column.
column and lower it until it sits on the shoulder
machined into the top of the column.
CAUTION:
The head assembly is quite
heavy; get assistance when lifting.
7.
Secure the head to the column by tightening
the 5mm setscrews
the 5mm setscrews
Figure 5.
worm pinion