Xantrex Technology 815-3524 ユーザーズマニュアル

975-0697-01-01

27

Installing the Inverter/Charger

Th

is g

u

id

e for use 

by 

qu

alified 

perso

nnel

 o

n

ly.

1.

Remove one of the AC knockouts from the front or side of the 
unit. Do not leave the knockout inside the wiring compartment.

2.

Install a strain-relief clamp in the AC knockout and run the AC 
wiring through the strain-relief clamp.

3.

Strip approximately 50 mm off the jacket from the AC cable 
and separate the wires.

4.

Using a 6 mm blade slot screwdriver, loosen the terminal 
screws on the AC output terminals. Do not remove the screws.

5.

Connect the line and neutral wires to the output terminals 
(labeled AC Output on the terminal block, Figure 6 on page 25) 
as follows: 
Connect Line to OUTPUT L, Neutral to OUTPUT N.

6.

Tighten the terminal screws. Leave some slack wire inside the 
wiring box.

7.

Connect the ground wires to a free position on the ground bus, 
Figure 6 on page 25. If solid ground wire is being used, the wire 
can be connected directly under the screw heads. If stranded 
ground wire is being used, ring terminals must also be used.

8.

Secure the strain-relief clamp on the AC output cable jacket.

9.

Attach the wiring compartment cover panel and tighten the four 
screws.

10. Connect the outgoing AC wires to an AC load panel equipped 

with circuit breakers.

Do not connect the output of the inverter to any AC source.

IMPORTANT: The applicable installation code may not allow you to run 
the AC input and AC output wiring through the same AC knockout.

Freedom SW 3K2K 230V InvChg Install Guide.book  Page 27  Friday, June 20, 2014  9:11 AM