Grizzly Model G8027 ユーザーズマニュアル

-12-

G8027 1 HP Dust Collector

Components and Hardware Needed:

Qty

Motor/Impeller Housing ......................................1
Collector .............................................................1
Base ...................................................................1
Rubber Gasket ...................................................1
Swivel Casters ....................................................4
Collection Bag Support Rods ............................ 2
Upper Bag Support Rod .....................................1
Impeller Housing Support ...................................1
Hex Bolts M6-1 x 15 ......................................... 6
Hex Bolts M8-1.25 x 15 ......................................8
Hex Nuts M5-.8 ................................................18
Hex Nuts M8-1.25 ..............................................4
Flat Washers 5mm ...........................................22
Flat Washers 8mm ...........................................12
Phillips Head Screws M5-.8 x 15 ...................... 6
Phillips Head Screws M5-.8 x 10 .................... 16
Phillips Head Screws M4-.7 x 8 ........................ 2

To assemble the dust collector base:

1. Make sure the dust collector motor is

unplugged!

2. Install the swivel casters onto the base with

sixteen M5-.8 x 10 Phillips head screws,
nuts, and flat washers (see

Figure 5).

Figure 5. Installing casters.

Figure 7. Installing motor/impeller housing on

collector support.

Base and Supports

Figure 6. Installing collector support.

3. Place the base right side up and install the

collector support (

Figure 6) using four M8-

1.25 x 15 hex bolts and four flat washers.

4. Place the motor/impeller housing onto the

collector support plate and fasten with four
M8-1.25 x 15 hex bolts, four hex nuts, and
eight flat washers as shown in

Figure 7.