Zenoah SGCZ2600DW ユーザーズマニュアル
GB-8
SGCZ2600DL/SGCZ2600DW
WARNING
Never use any screws other than those specified by
the manufacturer, or the engine can get loose, result-
ing in a hazardous event.
the manufacturer, or the engine can get loose, result-
ing in a hazardous event.
IMPORTANT
Tighten the screws gradually by turns.
MOUNTING ENGINE
1. Install the engine to the drive shaft so that the cylin-
1. Install the engine to the drive shaft so that the cylin-
der head and the stop switch may come on the same
side.
side.
2. Using attached four bolts, secure the connection firmly
with equal force (Torque: 25in-lbs)(Torque: 2.8 N.m.).
INSTALLING HANDLE <SGCZ2600DL>
• Mount the handle to the shaft tube and clamp it at a
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you.
INSTALLING HANDLE <SGCZ2600DW>
1. Loosen the 4bolts on the upper cap and insert the
1. Loosen the 4bolts on the upper cap and insert the
handles equally. Retighten the bolts.
2. Put the handle assembly into the bracket and put the
upper cap over it. Tighten the cap securely.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
6. Set up
CONNECTING SWITCH WIRES
• Connect the switch wires between the engine and the
• Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
HIP PAD
• Wrap the hip pad around the shaft tube as shown in
• Wrap the hip pad around the shaft tube as shown in
the figure, and fasten the hooks.
ANGLE TRANSMISSION
WARNING
The blade has very sharp edges. Be sure to use pro-
tective gloves whenever handling it.
tective gloves whenever handling it.
1. Remove the fastening screw(long) and the lock
screw(short) from the angle transmission.
2. While aligning the locking holes, install the angle trans-
mission assembly to the shaft casing.
3. While aligning the locking holes, install the bracket.
4. Align the locking holes and screw in the lock screw to
4. Align the locking holes and screw in the lock screw to
the bottom by hand, then secure it with the wrench
provided. Do not tighten up the lock screw with the
holes out of alignment, or the angle transmission can
be damaged.
provided. Do not tighten up the lock screw with the
holes out of alignment, or the angle transmission can
be damaged.
NOTE
If the locking screw is tightened up with the holes out of
alignment, the angle transmission may be damaged.
alignment, the angle transmission may be damaged.
5. Fasten the angle transmission fastening screw.
INSTALLING CUTTING ATTACHMENT GUARD
• Attach the cutting attachment guard with the bolts
• Attach the cutting attachment guard with the bolts
provided to the shaft.
Bolt
Bracket
(1)
(2)
(3)
Locking holes
Angle transmission
About 48cm