Festool PD561438 ユーザーズマニュアル

26 

TS 55 EQ Circular Saw 

If the gib cams are over tightened, or the saw is used in an 

environment with abrasive dust, the cams may develop flat 

spots and should be replaced. Maintaining proper 

adjustment and keeping the saw clean will increase the life 

of the cams.  

► 

Unplug the saw for safety, and lay the saw on its side on 

a stable work surface. 

► 

Using a T-15 Torx

®

 driver, remove the screw that secures 

each cam to the sole plate, and remove the cam and 

friction washer. 

► 

The replacement parts kit will 

include 2-cams, 2-friction washers, 

and 2-screws. 

► 

Install the new cams and friction 

washers with the screws provided.  

► 

Make sure the limit tabs are 

pointing away from the guide rail 

slot as shown. 

► 

Tighten the screws enough to 

compress the friction washers, but 

take care not to over tighten the 

screws. 

► 

 

The splinter guard prevents splintering and chipping of the 

workpiece by holding the top edge of the workpiece down as 

the teeth of the sawblade move upward against it. The 

splinter guard needs to be replaced if it becomes damaged or 

worn. 
1.  Peel the original splinter guard away from the guide rail. 
2.  As needed, clean residual adhesive and debris from the 

guide rail. 

3.  Peel off the plastic backing from the new splinter guard 

to expose the adhesive. 

4.  Without stretching the rubber, carefully place the new 

splinter guard on the underside of the guide rail tight to 

the alignment rib (14-b). 

5.  Make sure the splinter guard is firmly pressed down to 

the guide rail. 

6.  Trim the splinter guard as described on page 8.