Chicago Electric 69683 ユーザーズマニュアル

Page 12

Item 69683 

        

If a kerfing or rabbet cut which does not cut through the workpiece is desired, 

use the Depth Stop Bolt to control the depth of the cut.

1.  Unlock the Head Lock-down, see page 9.

2.  Raise the saw head assembly.

3.  Pull down on the saw head to 

check the current setting.

4.  Loosen the Depth Stop Nut on the Depth Stop Bolt.

5.  Turn the Depth Stop Bolt clockwise to decrease 

depth and counterclockwise to increase depth.

6.  Tighten the Depth Stop Nut after adjustment.

1.  Designate a work area that is clean and well-lit.  

The work area must not allow access by children 

or pets to prevent injury and distraction.

2.  Route the power cord along a safe route to reach 

the work area without creating a tripping hazard or 

exposing the power cord to possible damage.  The 

power cord must reach the work area with enough 

extra length to allow free movement while working.

3.  Allow room on both left and right of 

saw for extended workpieces.

4.  Use a saw table, saw stand or other means to 

support the workpiece. Mount the Miter Saw 

so that the surface is level to the ground, and 

additional supports provide a surface on the 

same level as the saw table. If the work surface 

and any workpiece supports are not level, and 

on the same level, unwanted bevel angles will 

appear in the cuts resulting in poor joinery.

5.  Secure workpieces to the saw table using the Clamp 

or other clamping devices (not included). Securing 

the workpiece will provide safety by preventing kick 

back and by removing the need to hold workpieces 

near the blade by hand. Clamping the workpiece 

will also improve cutting accuracy by preventing the 

workpiece from moving during the cutting operation.