Northern Industrial Tools M35982E ユーザーズマニュアル

CAUTION!  Do not operate without lubricant or with inadequate lubricant.

Use of compressor without  lubricant or inadequate lubricant  voids all warranties.

Synthetic lubricants are recommended after 50 hour break-in. Compressor life is greatly increased with the
use of synthetic lubricants. CAUTION! If you will be using synthetic lubricant, all downstream piping material
and system components must be compatible.

Suitable Viton

, Teflon, Epoxy (Glass Filled), Oil Resistant Alkyd, Fluorosilicone, Flourocarbon,

Polysulfide, 2-Component Urethane, Nylon, Delrin

, Celcon, High Nitrile Rubber (Buna N. NBR more

than 36 Acrylonite), Polyurethane, Polyethylene, Epichlorohydrin, Polyacrylate, Melamine,
Polypropylene, Baked Phenolics, Epoxy, Modified Alkyds
( 

 indicates trademark of DuPont Corporation)

Neoprene, Natural Rubber, SBR Rubber, Acrylic Paint, Lacquer, Varnish, Polystyrene, PVC, ABS,
Polycarbonite, Cellulose Acetate, Latex, EPR, Acrylics, Phenoxy, Polysulfones, Styrene Acrylonitile
(San), Butyl

You may use petroleum-based lubricant that is premium quality, does not contain detergents, contains only
anti-rust, anti-oxidation, and anti-foam agents as additives, has a flashpoint of 440

°F (227°C) or higher, and

has a auto-ignition point of 650

°F (343°C) or higher.

See the petroleum lubricant viscosity table below. The table is intended as a general guide only. Heavy duty
operating conditions require heavier viscosities. Refer specific operating conditions to NorthStar Customer
Service at 1-800-270-0810 Monday - Friday 7:00 AM-5:30 PM, Saturday 7:30 AM-11:30 AM Central Standard
Time.

Below 40

°F (4°C)

100

30

40

°F  to 80°F

(4

°C to 27°C)

100

30

80

°F to 100°F

(27

°C to 37°C)

150

40

Pump Capacities.
Refer to the following table for crankcase capacity

45929

24 oz.

45930

36 oz.