Grizzly G0656X ユーザーズマニュアル

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#BL10444 PRINTED IN CHINA

Clean Up

(See Page 13)

The following sliding surfaces must be cleaned:
•

Fence carriage

•

Fence bracket

Assembly

(See Page 14)

Assembly of the fence bracket, fence carriage
assembly, and handwheels has changed.

Steps

2-5 below replace Steps 15-17 on Page 15 of the
G0656 Owner's Manual.

1. Follow Steps 1-14 on Pages 14 & 15.

2. Align the mounting holes on the fence bracket

and jointer, and fasten with the M8-1.25 x 35
cap screws, flat washers and lock washers,
as shown in

Figure 2. Do not fully tighten the

fasteners yet.

This update covers changes made to the machine after the owner's manual was printed. All page num-
ber references refer to the owner's manual for this machine. Keep this update with your owner's man-
ual for future reference. If you have questions, contact Tech Support at (570) 546-9663 or by email at
techsupport@grizzly.com.

MODEL G0656

8" JOINTER w/BUILT-IN

MOBILE BASE

MANUAL UPDATE

The items below have been added to the original
list of included assembly fasteners:

Assembly Fasteners

Qty

•

Cap Screws M8-1.25 x 35 (Fence) ............ 4

•

Lock Washers 8mm (Fence) ...................... 4

•

Flat Washers 8mm (Fence) ........................ 4

•

Key 4 x 4 x 12 (Right Handwheel) ............. 1

Machine Inventory

(See Page 11)

The fence assembly and fence bracket are no
longer pre-installed on the jointer assembly by
the factory for shipping, as shown in

Figure 3 on

G0656 Manual

Page 11. These items have been

added to the machine inventory (

Figure 1). Refer

to the owner's manual for the rest of the inven-
tory.

Wood Crate (Figure 1):

Qty

A. Fence Bracket ........................................... 1

B. Fence Assembly ........................................ 1

Figure 1. New inventory items.

Fence

Bracket

Figure 2. Fence bracket installed.