Jet Tools J-A5816 ユーザーズマニュアル
11
Adjustments
Table Adjustment
The table can be raised or lowered to accommodate
the height of the component being drilled (refer to
Figure 4). To raise or lower the table, loosen the
lock handle. Then use the hand crank to move the
table to the desired height. Then retighten the lock
handle.
the height of the component being drilled (refer to
Figure 4). To raise or lower the table, loosen the
lock handle. Then use the hand crank to move the
table to the desired height. Then retighten the lock
handle.
Figure 4 – Table Adjustment
Head Adjustment
Change the radial position of the
drill head only if the drill press base is secured
to the floor. Swinging the drill head without the
base being secured to the floor will cause the
drill press to become unstable and tip over
resulting in injury and/or damage to the machine.
to the floor. Swinging the drill head without the
base being secured to the floor will cause the
drill press to become unstable and tip over
resulting in injury and/or damage to the machine.
The radial position of the drill head can be changed
to accommodate the drilling of a hole that may be
offset from the center of the table. Reposition the
drill head by loosening the locking handles and
swinging the drill head to the desired position. Then
retighten the locking handles.
to accommodate the drilling of a hole that may be
offset from the center of the table. Reposition the
drill head by loosening the locking handles and
swinging the drill head to the desired position. Then
retighten the locking handles.
Wiring Diagrams
Refer to Figure 5 for wiring information. The drive
motor is115/230 volt single phase or 220/440 volt
three phase. Notice: When converting machine
voltage, it is necessarry to re-wire the LED display
connection accordingly. Refer to figure 5.
motor is115/230 volt single phase or 220/440 volt
three phase. Notice: When converting machine
voltage, it is necessarry to re-wire the LED display
connection accordingly. Refer to figure 5.
Figure 5