Pelco C1498M-B ユーザーズマニュアル
Pelco Manual C1498M-B (7/99)
11
Software controls scan limit stops. When the dome reaches one, it immediately reverses
direction. Refer to the
direction. Refer to the
Limit Stops
section to program the scan limit stops. Program preset
96 (29) to stop a scan. Any pan and tilt or lens command also stops a scan.
PARK
If the dome does not receive any commands for a specified period, it goes to preset 1 and
parks. The dome will not park if the time specified is zero or preset 1 has not been
programmed. The default is zero minutes.
parks. The dome will not park if the time specified is zero or preset 1 has not been
programmed. The default is zero minutes.
PROGRAMMING THE SPECTRA
LITE™
The dome can be programmed for the following functions:
AGC (automatic gain control)
Camera reset
Scan speed
Auto flip disable
Gain
Sharpness
Auto focus
Limit stops
Shutter speed
Auto park time
Power line synchronization
White balance
Backlight compensation
Power-up mode
The main menu contains four secondary menus: Camera, Line Sync, Power Up, and Other.
Each secondary menu has submenus, which are structured as follows:
Each secondary menu has submenus, which are structured as follows:
1. Camera
First Camera Submenu
Second Camera Submenu
Backlight comp
Shutter speed
Reset camera
Auto focus mode
Gain/AGC
Sharpness
AGC mode
Sharpness
Gain
White balance
Auto-iris
Auto white bal
Auto-iris mode
White bal hue
Auto-iris level
Prev (to first camera submenu)
Next (to second camera submenu)
2. Line Sync
3. Power Up
4. Other
Line sync
Power up
Auto flip
Line sync phase
Limit stops
Park time minutes
Scan speed deg/s
Park time minutes
Scan speed deg/s
The following sections explain how to program the Spectra
Lite™ dome using the menu choices.
MAIN MENU ACCESS
You can call up the main menu on your monitor by programming (setting or creating) preset
95 (28). Programming preset 95 for Pelco’s controllers varies according to the type of
controller you are using. Below are instructions for programming preset 95 for various Pelco
controllers.
95 (28). Programming preset 95 for Pelco’s controllers varies according to the type of
controller you are using. Below are instructions for programming preset 95 for various Pelco
controllers.
CM6700
1.
Enter the number of the Spectra
Lite™ camera and press the CAM key.
2.
Enter 95 and hold the PRESET key for two seconds.
3.
In the Edit Preset menu, arrow to SET and press the ACK key. The main menu appears.
CM8500
1.
Enter the number of the Spectra
Lite™ camera and press the CAM key.
2.
Highlight PRESET in the Camera menu and hold down the joystick button until the Set
Presets prompt appears.
Presets prompt appears.
3.
Enter 95 and press the PRESET key. The main menu appears.
CM9500
1.
Enter the number of the Spectra
Lite™ camera and press the CAM key.
2.
Press the SELECT key twice.
3.
Highlight CAM in the Setup menu and press the SELECT key.
4.
Highlight PRESET in the Camera menu and press the SELECT key.
5.
Enter 95 and press the F1 key. The main menu appears.