Toshiba EO1-33085 ユーザーズマニュアル

 

12- 1 

■  The Power Switch is turned on, but the Power LED does not illuminate. 

The Power Cord is not 
connected into the wall outlet 
completely. 

Turn the Power Switch off.    Plug the Power Cord into the AC 
outlet completely.  (

→ 2.3 Connecting the Power Cord) 

Then, turn on the Power Switch again.   

The Power Cord is not 
connected into the printer 
completely. 

Turn the Power Switch off.    Connect the Power Cord into the 
AC Power Inlet at the back of the printer.    (

→ 2.3 

) Then, turn on the Power 

Switch again.   

The AC outlet is not 
functioning correctly. 

Plug a properly working electrical appliance into the AC outlet 
in question.    Check and see that nothing is wrong with the AC 
outlet. 

The Power Switch is not 
turned on correctly. 

Turn the Power Switch on.    (|) indicates the power ON side. 

 

 

■  Printing does not start. 

“READY” is not shown on the 
Operation Panel. 

If “PAUSE” is shown on the Operation Panel, printing 
cannot be performed. 
Ensure that the Front Cover and Side Cover are closed. 
Press the [Pause] key and confirm that “READY” appears 
on the Operation Panel.   

The printer driver has not been 
installed correctly. 

Check the settings of the computer to which the printer is 
connected.    If any wrong settings are found, correct them.
Check the following points. 

•  The installed printer driver is supported by an 

operating system of the computer. 

•  The installed printer driver is proper for the printer.