Toshiba B-EV4D SERIES ユーザーズマニュアル

2. PRINTER SETUP

ENGLISH VERSION EO1-33088

2.7 Loading the Media

E2- 7

2.7 Loading the Media

This section describes how to load a media in the printer. This printer
accepts label rolls, tag rolls, and fanfold paper stocks. Please use
TOSHIBA TEC approved media.

NOTES:

1. Please perform a media sensor calibration whenever you change the

media type.

2. The size of the media which can be loaded inside the printer is as

follows:

Outer roll diameter: Max. 127mm (5”)
Inner core diameter: 25.4 (1”) mm or 38.1 mm (1.5”)

When the outer roll diameter exceeds 127 mm or the inner core
diameter exceeds 38.1 mm, an optional External Media Roll Hanger
is required. For details, refer to the Installation Guide for the
External Media Roll Hanger.

3. Some media rolls are wound inside and the others are wound outside.

(See the diagram below.) Both types of media roll should be loaded
so that the print side faces up.

1. Press down the Top Cover Release Button to unlock the Top Cover,

then fully open the Top Cover.

WARNING!

1. Do not touch any moving

parts. To reduce the risk

of fingers, jewellery,

clothing, etc. being drawn

into the moving parts, be

sure to load the media

once the printer has

stopped moving

completely.

2. To avoid injury, be careful

not to trap your fingers

while opening or closing

the Top Cover.

CAUTION!

Be careful not to touch the
Print Head Element when
opening the Top Cover.
Failure to do this may cause
missing dots by static
electricity or other print quality
problems.

Top Cover Release
Button

Top Cover

Outside wound

Inside wound