Netgear UTM25EW-100NAS ユーザーズマニュアル

ページ / 480
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Virtual Private Networking Using IPsec Connections
7-3
v1.0, September 2009
Using the IPsec VPN Wizard for Client and Gateway 
Configurations
You can use the IPsec VPN Wizard to configure multiple gateway or client VPN tunnel policies.
The section below provides wizard and NETGEAR 
ProSaf
e VPN Client Software configuration 
procedures for the following scenarios:
Using the wizard to configure a VPN tunnel between two VPN gateways.
Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client.
Configuring a VPN tunnel connection requires that all settings on both sides of the VPN tunnel 
match or mirror each other precisely, which can be a daunting task. The VPN Wizard efficiently 
guides you through the setup procedure with a series of questions that determine the IPsec keys 
and VPN policies it sets up. The VPN Wizard also configures the settings for the network 
connection: security association (SA), traffic selectors, authentication algorithm, and encryption. 
The settings that are used by the VPN wizard are based on the recommendations of the VPN 
Consortium (VPNC), an organization that promotes multi-vendor VPN interoperability.
Creating Gateway-to-Gateway VPN Tunnels with the Wizard
To set up a gateway-to-gateway VPN tunnel using the VPN Wizard.
1. Select VPN > IPsec VPN from the menu. The IPsec VPN submenu tabs appear, with the IKE 
Policies screen in view.
2. Click the VPN Wizard submenu tab. The VPN Wizard screen displays (see 
, which contains some examples for the UTM25). The WAN1 and WAN2 radio 
buttons are shown on the VPN Wizard screen for the UTM25 but not on the VPN Wizard 
screen for the UTM10.
Figure 7-3