Netgear UTM25EW-100NAS ユーザーズマニュアル

ページ / 480
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
System Logs and Error Messages
C-7
v1.0, September 2009
PPP Logs
This section describes the WAN PPP connection logs. The PPP type can be configured through the 
Web Management Interface (see 
PPPoE Idle-Timeout Logs
Table C-10. System Logs: WAN Status, PPPoE Idle-Timeout 
Message 1
Message 2
Message 3
Message 4
Message 5
Message 6
Message 7
Message 8
Message 9
Message 10
Message 11
Nov 29 13:12:46 [UTM] [pppd] Starting connection
Nov 29 13:12:49 [UTM] [pppd] Remote message: Success
Nov 29 13:12:49 [UTM] [pppd] PAP authentication succeeded
Nov 29 13:12:49 [UTM] [pppd] local IP address 50.0.0.62
Nov 29 13:12:49 [UTM] [pppd] remote IP address 50.0.0.1
Nov 29 13:12:49 [UTM] [pppd] primary DNS address 202.153.32.3
Nov 29 13:12:49 [UTM] [pppd] secondary DNS address 202.153.32.3
Nov 29 11:29:26 [UTM] [pppd] Terminating connection due to lack of activity.
Nov 29 11:29:28 [UTM] [pppd] Connect time 8.2 minutes.
Nov 29 11:29:28 [UTM] [pppd] Sent 1408 bytes, received 0 bytes.
Nov 29 11:29:29 [UTM] [pppd] Connection terminated.
Explanation
Message 1: PPPoE connection establishment started.
Message 2: Message from PPPoE server for correct login 
Message 3: Authentication for PPP succeeded.
Message 4: Local IP address assigned by the server. 
Message 5: Server side IP address. 
Message 6: primary DNS configured in WAN status page.
Message 7: secondary DNS configured in WAN status page.
Message 8: The PPP link has transitioned to idle mode. This event occurs if 
there is no traffic from the LAN network.
Message 9: The time in minutes for which the link has been up.
Message 10: Data sent and received at the LAN side during the link was up.
Message 11: PPP connection terminated after idle timeout
Recommended Action
To reconnect during idle mode, initiate traffic from the LAN side.