Netgear UTM25EW-100NAS ユーザーズマニュアル

3-1

This chapter contains the following sections:

•

 on this page.

•

.

•

•

•

•

Generally, five steps are required to complete the Internet connection of your UTM:

1. Configure the Internet connections to your ISP(s). During this phase, you connect to your 

ISPs. You can also program the WAN traffic meters at this time if desired. See 

.

2. Configure the WAN mode (required for the UTM25’s dual WAN operation). For both the 

UTM10 and UTM25, select either NAT or classical routing. For the UTM25 only, select either 
dedicated (single WAN) mode, auto-rollover mode, or load balancing mode. For the UTM25’s 
load balancing, you can also select any necessary protocol bindings. See 

.

3. Configure secondary WAN addresses on the WAN ports (optional). Configure aliases for 

each WAN port. See 

.

Note: The initial Internet configuration of the UTM is described in 

.” If you used the Setup 

Wizard to configure your Internet settings, you need this chapter only to configure 
WAN features such as Dual WAN and Dynamic DNS, and to configure secondary 
WAN addresses and advanced WAN options.