Netgear UTM25-100NAS ユーザーズマニュアル

1-12

Introduction

The rear panel of the UTM includes a cable lock receptacle, a console port, a reset button, and an 
AC power connection.

Viewed from left to right, the rear panel contains the following components:

1. Cable security lock receptacle.

2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male 

connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.

3. Factory default Reset button. Using a sharp object, press and hold this button for about eight 

seconds until the front panel Test light flashes to reset the UTM to factory default settings. All 
configuration settings are lost and the default password is restored.

4. AC power receptacle. Universal AC input (100-240 VAC, 50-60 Hz).

The product label on the bottom of the UTM’s enclosure displays factory default, regulatory 
compliance, and other information (see