Netgear UTM25-100NAS ユーザーズマニュアル

2-1

Typically, the UTM is installed as a network gateway to function as a combined LAN switch, 
firewall, and content scan engine in order to protect the network from all incoming and outgoing 
malware threats.

Generally, five steps are required to complete the basic and security configuration of your UTM:

1. Connect the UTM physically to your network. Connect the cables and restart your network 

according to the instructions in the installation guide. See the ProSecure Unified Threat 
Management UTM10 or UTM25 Installation Guide for complete steps. A PDF of the 
Installation Guide is on the NETGEAR website at 

 or

2. Log in to the UTM. After logging in, you are ready to set up and configure your UTM. See 

.

3. Use the Setup Wizard to configure basic connections and security. During this phase, you 

connect the UTM to one or more ISPs (more than one ISP applies to the UTM25 only). See 

.

4. Verify the installation. See 

5. Register the UTM. 

Each of these tasks is described separately in this chapter. The configuration of the WAN mode 
(required for dual-WAN operation for the UTM25), dynamic DNS, and other WAN options is 
described in 

.”

The configuration of LAN, firewall, scanning, VPN, management, and monitoring features is 
described in later chapters.