Netgear UTM25-100NAS ユーザーズマニュアル

Troubleshooting and Using Online Support

12-5

•

If the computer is configured correctly, but still not working, ensure that the UTM is 
connected and turned on. Connect to the Web Management Interface and check the UTM’s 
settings. If you cannot connect to the UTM, see the information in the previous section 
(

•

If the UTM is configured correctly, check your Internet connection (for example, your modem 
or router) to make sure that it is working correctly.

If your UTM is unable to access the Internet, you should first determine whether the UTM is able 
to obtain a WAN IP address from the ISP. Unless you have been assigned a static IP address, your 
UTM requests an IP address from the ISP. You can determine whether the request was successful 
using the Web Management Interface.

To check the WAN IP address: 

1. Launch your browser and navigate to an external site such as www.netgear.com

2. Access the Web Management Interface of the UTM’s configuration at https://192.168.1.1 

3. Select Network Security > WAN Settings from the menu. The WAN1 ISP Settings screen 

(UTM25) or WAN ISP Settings screen (UTM10) displays. For the UTM25 only, to display the 
WAN2 ISP Settings screen, click WAN2 ISP Settings.

4. Click the WAN Status option arrow at the top right of the WAN1 ISP Settings or WAN2 ISP 

Settings screen of the UTM25, or at the top right of the WAN IPS Settings screen of the 
UTM10 .The Connection Status screen appears in a popup window. (For more information, 
see 

.)

5. Check that an IP address is shown for the WAN Port.

If 0.0.0.0 is shown, your UTM has not obtained an IP address from your ISP.

If your UTM is unable to obtain an IP address from the ISP, you might need to force your modem 
or router to recognize your new UTM by performing the following procedure:

1. Turn off the power to the modem or router.

2. Turn off the power to your UTM. 

3. Wait five minutes, and then turn on the power to the modem or router.

4. When the modem’s or router’s LEDs indicate that it has reacquired synchronization with the 

ISP, turn on the power to your UTM.