Mitsubishi Electronics 60/60S ユーザーズマニュアル

2.  Monitor 

2.2  COORDINATE 

 

 

 

I-32 

 

During automatic operation (memory or tape operation) or MDI operation, a block stop can be 
applied, and the next command can be corrected or changed. 
When a program error occurs, the block in which the error occurred can be corrected without 
resetting the NC, and operation can be continued. 

  (Note)  When running a machining program from the external memory, even if the buffer is 

corrected, the revisions are not reflected on the original program. 

 

Tape or
IC card

Memory

MDI

Preread
block

Execution
block

NC operation

Machine
control

Buffer correction

 

 

 

 

 
 

(a)  The next command can be corrected in the following two cases. 

• When single block stop is applied, and there is a machining program containing a next 

command to be corrected. 

• During automatic operation, there is an error (program error) in the next command's 

machining program, and the program is stopped. 

 

(b)  During memory or MDI operation, not only the displayed buffer data but also the memory and 

MDI contents are corrected with the buffer corrections.  

 
(c)  If an error occurs in the preread block, the block in which the error occurred can be corrected. 
 

(Note)  The buffers on the second and third pages of the COORDINATE screen cannot be 

corrected.