KYOCERA KM-2050 ユーザーズマニュアル

MemoryCard err Press 
GO

An error has occurred in writing to or reading from the Memory 
Card.

•

Press [Printer] and press 

S or T to select [GO] and press 

[Enter]. The error is cleared.

—

Memory card error Insert 
again.

The Memory Card has been removed during printer setup.
Insert the Memory Card.

When inserting the Memory Card, switch off the main 

power (

{

).

—

Insert same memory 
card

The machine tried to read data from the Memory Card and did not 
recognize the Memory Card.
Insert the Memory Card again.

When inserting the Memory Card, switch off the main 

power (

{

).

—

Format error Memory 
card

The Memory Card inserted in the machine must be formatted.
Format the Memory Card.

—

Print overrun Press GO. Printing has not been performed correctly due to insufficient 

memory.

•

Press [Printer] to display the following messages.

-

GO: Continues printing. Processed data will be output and 
remaining data will be printed on the next page.

-

CANCEL: Cancels printing.

-

RESET: Resets the printer board. In this case, only the 
printer functions will be reset.

•

Press 

S or T to select the option required and press [Enter].

If the Auto Continue setting has been enabled, printing 
automatically resumes after a preset period of time.
After this error message displays, Page Protect mode is 
automatically enabled.

—

Interface occupied

The selected interface is currently being used. Wait for a while 
and retry.

—

Checksum Error

The machine has detected an error at startup.
Switch off the main power and then switch on again. If the same 
message appears, contact your Service Representative or 
Authorized Service Center.

—