Sharp MXC300W ユーザーズマニュアル

This setting is used to select the beep pattern that 
signals the end of transmission or reception. 
"Pattern 1", "Pattern 2" or "Pattern 3" can be selected.
Before pressing the [OK] key to store your selection, you 
can press the 

 key to listen to the selected pattern.

This setting is used to select the length of the end sound
in seconds. Selections are "2.0 sec", "2.5 sec", "3.0 sec",
"3.5 sec", and "4.0 sec". "3.0 sec" is normally selected.

If multiple telephone numbers have been assigned to 
your telephone line, the number called can be 
identified by its ringing pattern. By using one number 
for voice calls and another number for faxes, you can 
tell which type of call you are receiving by the ringing 
pattern. You can set your machine to automatically 
receive faxes when your fax number is called by 
setting the pattern that corresponds to your fax 
number. Normally "Off" is selected.

When a call is received on an extension phone 
connected to the machine, fax reception can be 
activated by entering a 1-digit number and pressing 

 

twice on the phone's keypad. This 1-digit number is 
called the remote reception number, and you can set it 
to any number from "0" to "9". Normally the remote 
reception number is set to "5".

This setting is used to disable the fax print hold 
function,
which holds received faxes in memory instead of
printing them as they are received. (p.97)
Normally the fax print hold function is disabled.
•

The setting (which disables fax print hold) is 
enabled and a checkmark appears in the checkbox.

•

If this procedure is performed when the setting is 
enabled, the checkmark will be cleared and the 
setting disabled (fax print hold is enabled).

If a remote number has been previously 
stored, the newly entered remote number 
overwrites the old number.