Muratec F-315 ユーザーズマニュアル

10-4 u

ser

 

settInGs

The fax settings allows you to customize various fax settings to match your needs. 

Press <Menu>, <2>, <2>.

Press <Enter>.

Use <q> or <p> to search the item you want to set or change and press <Enter>.

Change settings and press <Enter>.  For details of each setting, refer to the table 

below:

When you have finished, press <Reset> to return to the standby mode.

The underlined settings are factory defaults.

01. Scan Parameters

Resolution 

You can choose one of the following.

Normal 

Scan at 8 dots/mm × 3.85 lines/mm

Fine 

Scan at 8 dots/mm × 7.7 lines/mm

S-Fine 

Scan at 8 dots/mm × 15.4 lines/mm

Gray 

Scan at 8 dots/mm × 7.7 lines/mm

Contrast  

You can choose one of the following.

S-Fine Resol.  You can choose one of the following.

02. Print Parameters

Rx Reduc. Rate    See page 5-6.

Auto 

Automatically reduces printouts at variable 

rates down to a minimum of 50%.  Tries to 

reduce printout to fit on one sheet of your 

selected paper size.  If it can’t, print the 

received document at 100% size on two or more 

pages.

100% 

Does not reduce the received documents.

Margin  Sets the reduction margin for Auto reduction. (00 to 85 mm)

Off 

Will not combine the half-page receptions.

On 

Combines two of half-page receptions onto a 

single sheet.

*  When the MFX-1950, the following menu will be displayed.
Paper Save

Off 

Will not perform either half-page receptions or 

duplex receptions.

H.Page Rx  Combines two half-page receptions onto a single 

sheet.

Duplex Rx  Combines and prints the received two one-sided 

pages onto both sides of a single sheet.