Sharp MXC250 ユーザーズマニュアル

This setting is used to have the activity report that is 
stored in the machine's memory printed out at regular 
intervals.
You can choose to have the report automatically 
printed each time the number of stored transactions 
exceeds 50, or have the report printed at a specified 
time every day (only once per day). You can also 
enable both print methods.
The report is normally set to not print out. To have the 
report automatically printed when the number of stored 
transactions (the combined total of transmissions and 
receptions) exceeds 50, select "Auto Print Rept At 
Limit(50)".
To have the report printed at a specified time, enable 
"Print Time Set" and enter the desired time.
•

The setting is enabled and a checkmark appears in 
the checkbox.

•

If this procedure is performed when the setting is 
enabled, the checkmark will be cleared and the 
setting disabled.

These settings are used to change the default settings
(initially set at the factory) for the various fax functions
to settings that better meet your needs.
Select the [Initial Setting] to configure the settings.

This setting is used to set the appropriate dial mode for
the line connected to the machine. Select tone for a
tone dial line or pulse for a pulse dial line.

This setting is used to select the duration of pauses 
that are inserted in destination fax numbers.
Normally the setting is 2 seconds, which means that 
each time the [PAUSE] key is pressed when dialing or 
storing a fax number, a pause of 2 seconds is inserted.
The pause time can be set to any number of seconds 
from 1 to 15.

Use this setting to setting the fax number of the 
machine and the name of the user. The programmed 
name and number are printed at the top of each fax 
page you send. The number is also used as a 
passcode when performing polling reception 
"SENDING OPTIONS" (p.100)".
You can check your programmed name and number 
by printing out the "List Print" (p.181)
A maximum of 20 digits can be stored for the fax 
number.
•

A maximum of 18 letters can be stored for the 
name.

This setting is used to adjust the on-hook volume, the 
ringing volume, the line monitor volume, the TX/RX 
end sound volume, the original scanning end sound 
volume, and the tone output volume. All volume 
settings are initially set to "Middle".
•

"High", "Middle" or "Low" can be selected for the on 
hook volume.

•

"High", "Middle", "Low" or "Off" can be selected for 
volumes other than the on hook volume.

• To cancel a "Print Time Set" setting, 

select "Cancel":

• Select "Cancel" with the [

] or [

] key 

and then press the [OK] key.

• If "Auto Print Rept At Limit(50)" is not 

enabled and the number of recorded 
transactions exceeds 50, each new 
transaction will delete the oldest 
transaction.

• The activity report can also be printed out 

on demand. (See "PRINTING LISTS OF 
PROGRAMMED INFORMATION AND 
SETTINGS" (p.109).)

To clear the programmed fax number and 
name, follow these steps:
(1) Select "Delete" and then press the [OK] 

key.

(2) Select "Delete" with the 

] or [

] key 

and then press the [OK] key.