Sharp TINSE2026QSZZ ユーザーズマニュアル
93
5
JOB PROGRAM MEMORY
If you frequently use the same settings for copy jobs, you can store in the settings in a job program. Up to 10 job
programs can be stored, and the programs are retained even when the power is turned off. By storing frequently
used copy settings in a program, you can eliminate the bother of selecting the settings each time you use them for a
copy job.
● After a job program is stored, if any settings of the administrator settings related to the stored job program are
programs can be stored, and the programs are retained even when the power is turned off. By storing frequently
used copy settings in a program, you can eliminate the bother of selecting the settings each time you use them for a
copy job.
● After a job program is stored, if any settings of the administrator settings related to the stored job program are
prohibited, the related settings in the job program will not be recalled.
● If the overwriting of job programs is prohibited in the administrator settings, it will not be possible to overwrite or
delete a job program.
● To exit job program memory mode, press the [CLEAR ALL] key ( ) on the operation panel or touch the [EXIT] key
on the touch panel.
STORING A JOB PROGRAM
1
Press the [#/P] key (
).
2
Touch the [STORE/DELETE] key.
3
Touch a program number from 1 to 10
in the storage register screen.
in the storage register screen.
4
Select the copy settings that you wish
to store in the program.
to store in the program.
The number of copies
cannot be stored.
cannot be stored.
5
Touch the [OK] key.
The selected settings will
be stored under the
program number
selected in step 3.
be stored under the
program number
selected in step 3.
If a numeric key is selected that has already
been programmed, a confirmation screen
will appear. To replace the existing program
with the new program, touch the [STORE]
key and continue from step 4. If you do not
wish to replace the existing program, touch
the [CANCEL] key to return to the above
screen and select a different numeric key.
been programmed, a confirmation screen
will appear. To replace the existing program
with the new program, touch the [STORE]
key and continue from step 4. If you do not
wish to replace the existing program, touch
the [CANCEL] key to return to the above
screen and select a different numeric key.
LOGOUT
NUMBER.
ECALL
STORE/DELETE
ROGRAMS
SS PROGRAM NUMBER.
RECALL
STORE
Note
8½x11
8½x14
SPECIAL MODES
2-SIDED COPY
OUTPUT
TO STORE, MAKE SELECTIONS AND PRESS
[OK], TO DELETE, PRESS [CANCEL].
[OK], TO DELETE, PRESS [CANCEL].
8½x11
AUTO
EXPOSURE
AUTO 8½x11
PAPER SELECT
100%
COPY RATIO
D PRESS
EL].
EL].
CANCEL
8½x11
8½x14
OK
MX-M310.book 93 ページ ２００９年７月６日 月曜日 午後６時５７分