Metrologic Instruments IS1000 ユーザーズマニュアル
IS1000 – Configuration Guide
5
START OF CONFIGURATION
END OF CONFIGURATION
2. COMMUNICATION
MODES
The radio base is equipped with a decoder offering a multi-interface communication port.
The default communication mode is RS232 (9600 baud, 7 data bits, parity even, 1 stop bit, end
message: CR LF).
message: CR LF).
Other communication modes can be selected by using the following sequence:
Read the code Start of Configuration
bottom left of each page
Read the code End of Configuration
bottom right of each page
Select the mode of communication
Adjust the transmission parameters