Sharp MX-M182D ユーザーズマニュアル

The copy is delivered to 
the paper output tray. 

The original size appears 
in the display and the 
most suitable paper size 
is automatically selected.
Insert the stack into the 
document feeder tray until 
it stops.

The copies are delivered to the 
centre tray.
The default output mode for 
copying from the SPF/RSPF is 
sort mode. 

The output mode can be 
changed using the automatic 

sort selection setting in the system settings. 

• The centre tray can hold a maximum of 

250 sheets (150 sheets when the job 
separator tray kit is installed).

• About one minute after copying ends, 

"Auto clear" 

 activates and restores 

the copy settings to the default settings. 
The setting for "Auto clear" can be 
changed in the system settings. 

• To cancel a copy job in progress, press 

the [C] key.

• Differences in copy conditions may cause 

the position of the printed copy image to 
vary even the copies are of the same 
original on the same paper. For more 
information, see "Points concerning the 
position of the printed copy image" on 

• If the original is a non-standard size or the 

size was not detected correctly, see 
"SELECTING THE ORIGINAL SIZE" 

.

• If the auto paper select function has been 

disabled in the system settings 

, 

use the [PAPER SELECT] key to select 
the desired paper size.

• To copy onto paper of a different size, 

press the [PAPER SELECT] key and 
select the desired paper size.

• Paper in a different orientation from the original 

may be selected if the auto paper select or 
auto image function has been selected. In this 
case, the image of the original will be rotated.

• To use the bypass tray, select it manually.
• Do not place originals of different sizes 

together in the document feeder tray. This 
may cause misfeeds.

Do not place originals of different sizes 
together in the document feeder tray. This 
may cause misfeeds.

• The centre tray can hold a maximum of 

250 sheets (150 sheets when the job 
separator tray kit is installed).

• About one minute after copying ends, 

"Auto clear" 

 activates and restores 

the copy settings to the initial settings. 
The duration of time after which "Auto 
clear" clears the copy settings can be 
changed in the system settings. 

• To stop copying in the middle of a run, 

press the [C] key. If you find it difficult to 
remove the original from the document 
feeder tray, open the feeding roller cover 
before removing the original. If you pull 
out the original without opening the 
feeding roller cover, the original may 
become dirty.

MNO

WXYZ

@.-_

AD-END