Sharp MX-M182D ユーザーズマニュアル
88
TROUBLESHOOTING
6
A Notice Page (NP-001) has been
printed, but the print data has not
been printed completely.
printed, but the print data has not
been printed completely.
A print job containing more data than can be held in the
print memory is sent to the machine.
print memory is sent to the machine.
→ Disable the ROPM function on the "Configuration" tab of the
printer driver setup screen. If you need to use the ROPM function,
divide the pages of the print data into two or more print jobs.
divide the pages of the print data into two or more print jobs.
→ The memory allocated to the printer function can be changed in
the system setting "MEM. FOR PRINTER".
Printing is slow.
Simultaneous use of two or more application software
programs.
programs.
→ Start printing after quitting all unused application software programs.
–
The printed image is light and
uneven.
uneven.
The paper is loaded so that printing takes place on the
back side of the paper.
back side of the paper.
→ Some paper types have a front and back side. If the paper is
loaded so that printing takes place on the back side, toner will not
adhere well to the paper and a good image will not be obtained.
adhere well to the paper and a good image will not be obtained.
The printed image is dirty.
You are using paper that is outside the specified size and
weight range.
weight range.
→ Use copy paper within the specified range.
Paper curled or damp.
→ Do not use curled or crimped paper. Replace with dry copy paper.
During periods when the machine is not used for a long time,
remove the paper from the tray and store it in a dark place in a
bag to prevent moisture absorption.
remove the paper from the tray and store it in a dark place in a
bag to prevent moisture absorption.
–
You did not set sufficient margins in the paper settings of
your application.
your application.
→ The top and bottom of the paper may be dirty if the margins are
set outside of the specified print quality area.
→ Set the margins in the software application within the specified
print quality area.
–
The printed image is skewed or it
runs off the paper.
runs off the paper.
The paper loaded in the tray is not the same size as that
specified in the printer driver.
specified in the printer driver.
→ Check if the "Paper Size" options suit the size of the paper loaded
in the tray.
→ If the "Fit To Paper Size" setting is activated, make sure that the
paper size selected from the drop-down list is the same as the
size of the loaded paper.
size of the loaded paper.
–
The orientation of document setting is not correct.
→ Click the "Main" tab in the printer driver setup screen, and verify if
the "Image Orientation" option is set to your requirements.
–
Paper is not loaded properly.
→ Make sure the paper is properly loaded.
You did not correctly specify the margins for the
application in use.
application in use.
→ Check the layout of the document margins and the paper size
settings for the application you are using. Also check if the print
settings are specified correctly to suit the paper size.
settings are specified correctly to suit the paper size.
–
The image orientation setting in the printer driver is not
correct.
correct.
→ Click the [Paper] tab in the printer driver setup screen and make
sure the "Image Orientation" setting is correct.
Paper is not loaded properly.
→ Make sure the paper is properly loaded.
The margins are not set correctly in the application.
→ Check the paper size and margin settings in the application. Also
make sure that the print settings are correct for the paper size.
–
Problem
Cause and solution
Page