Sharp AL-1552 ユーザーズマニュアル
53
6
A: When copying in a one-sided to two-sided mode:
Use the original to copy key to select the desired one-sided to two-sided
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 52.
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 52.
B: When copying in the two-sided to two-sided mode:
Use the original to copy key to select the two-sided to two-sided copying
mode. The originals must be set in the SPF/RSPF before this mode can
be set (step 3) on page 48 (AL-1555).
mode. The originals must be set in the SPF/RSPF before this mode can
be set (step 3) on page 48 (AL-1555).
C: When copying in the two-sided to one-sided mode:
Use the original to copy key to select the two-sided to one-sided copying
mode. The originals must have been set in the SPF/RSPF in step 3 on
page 48 (AL-1555).
mode. The originals must have been set in the SPF/RSPF in step 3 on
page 48 (AL-1555).
3
Select the copy settings. See "SET THE COPY QUANTITY"
(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).
(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).
Using the original table
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
1
Press the start (
) key.
The original is scanned into the unit's memory.
2
Place the original that you wish to copy onto the rear side of the
paper, and press the start (
paper, and press the start (
) key again.
Copying begins.
Using the SPF/RSPF
Press the start (
Press the start (
) key. Copying begins in the selected two-sided copy mode.
A
B
A
AL-1552_AL-1553
AL-1555
C