Sharp MX-M182 ユーザーズマニュアル
99
TROUBLESHOOTING
REPLACING THE TONER CARTRIDGE
When the toner replacement icon (
) appears, little toner remains. Obtain a replacement cartridge as soon as possible.
When the message "
Add toner. Can not copy or print." appears in the display, the toner cartridge must be
replaced before copying can be resumed. Follow the steps below to replace the toner cartridge.
1
Push on both ends of the front cover
and open it.
and open it.
2
Pull the toner cartridge out while
pressing the lock release lever.
pressing the lock release lever.
When pulling out the
toner cartridge, place
your other hand on the
indentation of the
cartridge.
toner cartridge, place
your other hand on the
indentation of the
cartridge.
3
Remove the new toner cartridge from
the bag. Grasp the cartridge on both
sides and shake it horizontally four or
five times.
the bag. Grasp the cartridge on both
sides and shake it horizontally four or
five times.
4
Insert the toner cartridge along the
guides until it locks in place while
pushing the lock release lever.
guides until it locks in place while
pushing the lock release lever.
If there is any dirt or dust
on the toner cartridge,
remove it before
installing the cartridge.
on the toner cartridge,
remove it before
installing the cartridge.
5
Close the front cover.
The toner cartridge
replacement required
indicator (
replacement required
indicator (
) will go
out.
• During a long copy run or when copying originals with many dark areas, the message "Toner replenishment in
progress." may appear and copying will stop even though toner remains. The machine will feed toner for about
2 minutes. When the START indicator lights up, press the [START] key (
2 minutes. When the START indicator lights up, press the [START] key (
) to resume copying.
• When the toner cartridge replacement required icon (
) appears in the display, little toner remains and thus
copies may be faint.
Note
After removing the toner cartridge, do not
shake it or tap on it. Doing so may cause
toner to leak from the cartridge. Put the old
cartridge immediately in the bag contained in
the box of the new cartridge. Dispose of the
old toner cartridge in accordance with local
regulations.
shake it or tap on it. Doing so may cause
toner to leak from the cartridge. Put the old
cartridge immediately in the bag contained in
the box of the new cartridge. Dispose of the
old toner cartridge in accordance with local
regulations.
Grasp the grip when holding the cartridge.
Toner cartridge
lock release lever
lock release lever
Caution
4 or 5 times
Caution
• Even after a new toner cartridge is
installed, the toner cartridge replacement
required indicator (
required indicator (
) may still light up,
indicating that copying cannot be resumed
(toner is not fed sufficiently). In this case,
open and close the front cover. The
machine will feed toner again for about two
minutes and then copying can be resumed.
(toner is not fed sufficiently). In this case,
open and close the front cover. The
machine will feed toner again for about two
minutes and then copying can be resumed.
• Before closing the front cover, make sure
that the toner cartridge is correctly installed.
• When closing the front cover, gently hold
both ends.
Note