Sharp UX-B800SE ユーザーズマニュアル

1. Installation

Plug the power cord into a 120 V, 60 Hz, 
grounded AC (3-prong) outlet.

Caution! Do not plug the power cord 
into any other kind of outlet. This will 
damage the machine and is not 
covered under the warranty.

Caution! Remove all packing tape 
before plugging in the power cord 
(see page 7), or damage to the 
machine may result.

The display will show [CHECK 
CARTRIDGE] until you install the print 
cartridge.

♦

It is recommended that you install 
surge protectors for the power and 
telephone lines. Surge protectors can 
be purchased at most telephone 
specialty stores.

SHARP UX-C80B replacement 
cartridge
Ink Save mode OFF: 

Approx. 480 letter pages

Ink Save mode ON

: 

Approx. 800 letter pages

(The initial cartridge has the same 
yield as the replacement cartridge.)

♦

Ink Save mode is initially turned off. 
To turn on Ink Save mode, see 
pages 45 and 49.

Caution! Do not open the cover while 
the machine is printing.

Note: Keep print cartridges sealed in 
their packages until you are ready to 
install them. It is recommended that you 
do not use a cartridge that has been left 
unused for a long time after opening, as 
the print quality may be considerably 
degraded.

♦

Make sure the machine’s power cord 
is plugged in and paper is loaded in 
the paper tray.

Open the cover (grasp the finger 
grip).

If at any time the display shows [

PAPER &] / [PRESS START KEY

], 

check the paper tray. If the tray is 
empty, add paper. If there is paper in 
the tray, take it out and then reinsert it. 

When finished, press 

.