Sharp AR-M207 ユーザーズマニュアル

Follow these guidelines when using special paper.

• Use SHARP recommended transparency film and label sheets. Using other than SHARP recommended paper 

may result in misfeeds or smudges on the output.

• There are many varieties of special paper available on the market, and some cannot be used with this machine. 

Before using special paper, contact a SHARP service center.

• Before using other than SHARP recommended paper, make a test copy to see if the paper is suitable.

Make sure that the machine is not copying or printing, and then follow these steps to load paper.

If you are adding the same size 
of paper, go to step 3. If you are 
loading a different size of paper, 
go to the next step.

• The plate A is a slide-type 

guide. Grasp the locking knob 
on the guide and slide the 
guide to the indicator line of 
the paper to be loaded.

• The plate B is an insert-type 

guide. Remove it and then 
insert it at the indicator line of 
the paper to be loaded.

• When using 11" x 17" sized 

paper store the plate B in the 
slot at the left front of the 
paper tray.

Push the center of the pressure 
plate down until it locks into 
place.

Fan the paper well before 
loading it. If the paper is not 
fanned, double-feeds or 
misfeeds may occur.

Push the upper paper tray in 
completely.

Plate B

Plate A

• Do not load paper higher than the line on 

the tray (up to 250 sheets).

• Make sure that the paper fits under the 

tab on the right side of the tray.

• Make sure the stack of paper is straight 

before loading it. When adding paper, 
take the remaining paper out and combine 
it into a single stack with the new paper.

If the size of the loaded paper is different 
from the size shown in the display, be sure 
to follow the procedure in "CHANGING THE 
PAPER SIZE SETTING OF A TRAY" (page 
21) to change the paper size setting of the 
tray.