Sharp AR-M207 ユーザーズマニュアル

When auto paper select mode is enabled, "AUTO" appears in the paper size display. This function automatically 
selects paper that is the same size as the original (5-1/2" x 8-1/2", 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" 
x 14", 11" x 17", A5, B5, B5R, A4, A4R, B4, A3 paper).

• If a zoom setting is selected after placing the original, the paper size that is appropriate for the zoom setting will 

be automatically selected.

• Auto paper select mode is canceled if the auto zoom select function (page 52) is enabled or if a paper tray is selected 

with the [PAPER] key. Auto paper select resumes operation when the [CA] key is pressed or when "Auto clear" 
activates. Auto paper select mode can be disabled in the key operator programs. (See the "Key operator's guide".)

To copy large originals like newspapers, remove the 
document cover. To remove the cover, lift it straight 
up as shown. To replace the cover, do the reverse.
The SPF cannot be removed.

Press down on the SPF (or document cover) while 
copying as shown. If the SPF (or document cover) is 
not completely closed, shadows may appear on the 
copy or it may be fuzzy. Straighten originals with 
folds or creases well before placing.

Originals from 5-1/2" x 8-1/2" to 11" x 17" (A5 to A3) in 
size and 15 lbs. to 24 lbs. (56 g/m

2

 to 90 g/m

2

) in weight 

can be used. A maximum of 40 pages can be placed at 
once. For originals that are 8-1/2" x 14" or larger (B4 or 
larger), a maximum of 30 pages can be placed at once.

The following originals cannot be used: These may 
cause misfeeds or smudging and unclear images.

• Transparencies, tracing paper, other transparent 

or translucent paper, and photographs.

• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal transfer 

printing), originals on thermal transfer paper.

Even if the same original is copied onto the same type of paper, differences in the original size, scanning location 
(document glass or document feeder tray), selected paper tray, enlargement/reduction ratio, and other conditions 
may cause the position of the printed copy image on the paper to vary.
As shown in the following example, when an original smaller than the paper size (for example, 5-1/2" x 8-1/2" 
original and 11" x 17" paper) is copied from the document glass, the position of the printed copy image on the 
paper is different when paper from tray 1 is used (1) and paper from the bypass tray is used (2).

• Make sure that there are no paper 

clips or staples on the original.

• Straighten curled originals before placing 

them in the document feeder tray. Curled 
originals may cause misfeeds.

• If the margin shift function is being 

used, the margin shift settings may 
need to be changed. (Page 68)

11" x 17" paper

11" x 17" paper

5-1/2" x 8-1/2"

copy image

5-1/2" x 8-1/2"

copy image

(1)

(2)