Sharp AR-M207 ユーザーズマニュアル
51
COPY FUNCTIONS
4
USING THE BYPASS TRAY TO COPY A SPECIAL SIZE ORIGINAL
When the bypass tray is being used for copying and an original that is placed on the document glass is detected as
being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation,
follow the steps below.
being a special size, the display will prompt the user to set the original size. To make a copy in this type of situation,
follow the steps below.
1
Load paper in the bypass tray and
place the original on the document
glass.
place the original on the document
glass.
2
Touch the [PAPER] key and then
select the bypass tray.
select the bypass tray.
A message will appear asking you whether you wish to
set the original size or make the copy without setting it.
To make a copy without setting the original size, press
the [START] key (
set the original size or make the copy without setting it.
To make a copy without setting the original size, press
the [START] key (
). To set the original size, go to
step 3.
3
Press the [OK] key.
The original size selection screen appears with "SIZE
INPUT" selected.
INPUT" selected.
4
Select inches or AB with the [
] or
[
] key, and then select the original
size with the [
] or [
] key.
5
Press the [OK] key.
If "SIZE INPUT" was selected in step 4:
The size entry screen appears and is ready for entry of
the width of the original.
the width of the original.
If other than "SIZE INPUT" was selected in step 4:
You will return to the base screen. Go to step 8.
6
Select "X" (width) with the [
] or [
] key
and enter the width with the [
] or [
] key,
and then do the same for the length (Y).
7
Press the [OK] key.
You will return to the base
screen.
screen.
8
Press the [START] key (
).
Copying begins.
POSURE
PAPER
ZOOM
AUTO %
OUT
LOR MODE
ROGRAM
RESOLUTION
RESOLUTION
RESOLUTION
ADDRESS
FORMAT ORIGIN
ORIGIN
ADDRESS BROADCAST
[OK]:ORIG. SIZE
ENTER
ENTER
100%
EXTRA
EXTRA
AUTO
GHI
OK
BACK
ORIG. SIZE ENTER
8 x11R
5 x8
5 x8
SIZE INPUT
INCH
1
2
1
2
1
2
GH
PQR
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
If you selected AB in step 4, the screen will be
ready for you to enter the width in AB.
ready for you to enter the width in AB.
• Any number from 2-1/2" to 17" (64 mm to
432 mm) can be entered for the width, and
any number from 2-1/2" to 11-5/8" (64 mm
to 297 mm) can be entered for the length.
any number from 2-1/2" to 11-5/8" (64 mm
to 297 mm) can be entered for the length.
• The entered size is retained until the
power is turned off, even if "SIZE INPUT"
is selected again and the entry screen of
step 5 is displayed.
is selected again and the entry screen of
step 5 is displayed.
OK
SIZE INPUT
SIZE(inch)
X: 2
Y: 2
SIZE(inch)
X: 2
Y: 2
1
2
1
2
Note
SIZE INPUT
SIZE(inch)
X: 8
Y: 5
SIZE(inch)
X: 8
Y: 5
1
2
1
2
Note
OK
WXYZ
@.-_
READ-END