Sharp AL-2040CS ユーザーズマニュアル
12
POWER ON
Ensure that the power switch of the unit is in the OFF position. Plug the other end of
the power cord into the nearest outlet. Turn the power switch on the left side of the
unit to the "ON" position. The start (
the power cord into the nearest outlet. Turn the power switch on the left side of the
unit to the "ON" position. The start (
) indicator will light up and other indicators
which show the initial settings of the operation panel will also light up to indicate the
ready condition. For the initial settings, see "Initial settings of operation panel" (p.13).
ready condition. For the initial settings, see "Initial settings of operation panel" (p.13).
About the scan head
The scan head lamp remains on constantly when the unit is in the ready condition
(when the start (
(when the start (
) indicator is illuminated).
The unit adjusts the scan head lamp periodically to maintain copying quality. At this
time, the scan head moves automatically. This is normal and does not indicate unit
trouble.
time, the scan head moves automatically. This is normal and does not indicate unit
trouble.
If you use the unit in a country other than the country where the unit was
purchased, you will need to make sure that your local power supply is
compatible with your model. If you plug the unit into an incompatible
power supply, irreparable damage to the unit will result.
purchased, you will need to make sure that your local power supply is
compatible with your model. If you plug the unit into an incompatible
power supply, irreparable damage to the unit will result.
• Only insert the power cord into a properly grounded wall socket.
• Do not use extension cords or power strips.
• Do not use extension cords or power strips.
• The unit will enter a power save mode once the set time has elapsed
without any unit operation. The settings of the power save modes can
be modified. See "USER PROGRAMS" (p.55).
be modified. See "USER PROGRAMS" (p.55).
• The unit will return to the initial settings a preset amount of time after
the end of a job. The preset amount of time (auto clear time) can be
changed. See "USER PROGRAMS" (p.55).
changed. See "USER PROGRAMS" (p.55).
AL-2030_2040CS.book 12 ページ ２００７年４月６日 金曜日 午前１１時３２分